A.O. Smith Promax Tall ECT-52 Instruction Manual | Page 10
10
If after manually operating the valve, it fails to completely reset and
continues to release water, immediately close the cold water inlet to
the water heater, follow the draining instructions, and replace the
temperature-pressure relief valve with a new one.
FILLING THE WATER HEATER
Never use this water heater unless it is completely full of
water. To prevent damage to the tank and heating element,
the tank must be filled with water. Water must flow from the
hot water faucet before turning “ON” electrical supply to the
water heater. The manufacturer will not warrant any elements
damaged by failure to follow instructions.
To fill the water heater with water:
1. Close the water heater drain valve by turning the handle to
the right (clockwise). The drain valve is on the lower front of
the water heater.
2. Open the cold water supply valve to the water heater.
NOTE: The cold water supply valve must be left open
when the water heater is in use.
3. To insure complete filling of the tank, allow air to exit by
opening the nearest hot water faucet. Allow water to run
until a constant flow is obtained. This will let air out of the
water heater and the piping.
4. Check all water piping and connections for leaks. Repair
as needed.
5. Never alter or modify the certified construction of the water
heater or its components, or bypass any safety features.
Doing so voids all warranties.
T&P VALVE and PIPE INSULATION (On Selected Models)
Remove insulation for T&P Valve and pipe connections from carton.
Fit pipe insulation over the incoming cold water line and the hot water
line. Make sure that the insulation is against the top cover of the heater.
Fit T&P Valve insulation over valve. Make sure that the insulation
does not interfere with the lever or outlet of the T&P valve.
Secure all insulation using tape.
FIGURE 5.
PIPE INSULATION
Related Manuals for A.O. Smith Promax Tall ECT-52
-
A.O. Smith Water Heater BTX-100 Specification Sheet
2 pages
-
A.O. Smith Water Heater Cyclone BFC - 60 Installation Manual
98 pages
-
A.O. Smith Water Heater EES - 52 Specification Sheet
4 pages
-
A.O. Smith Water Heater ProMax Power-Vent GPVH-50 Instruction Manual
32 pages
-
A.O. Smith Water Heater Promax Short ECS-40 Instruction Manual
28 pages
-
A.O. Smith Water Heater Promax Tall ECT-55 Instruction Manual
28 pages
-
A.O. Smith Water Heater Promax Tall ECT-80 Instruction Manual
28 pages
-
A.O. Smith Water Heater TJV-120M Specification Sheet
2 pages
-
Electrolux Water Heater EWH-SL/SLN User's Manual
4 pages
-
Whirlpool Water Heater E1F50RD045V User's Manual
16 pages
-
Whirlpool Water Heater Energy Smart EE2H40RD045V User's Manual
15 pages
-
Rheem Water Heater Ruud G100-200(A) User's Manual
2 pages
-
Redring Water Heater 1070810E User's Manual
8 pages
-
GSW Water Heater SUPERFLUE POWER VENTED GAS FIRED WATER HEATER User's Manual
18 pages
-
Rheem Water Heater Professional Prestige Series: Hybrid Heat Pump Use & Care Manual
24 pages
-
Rheem Water Heater Tankless Electric RTE 13 Use & Care Manual
16 pages
-
A.O. Smith Water Heater GCVL-40 Technical Documents
32 pages
-
A.O. Smith Water Heater ATI-540H-N Technical Documents
64 pages
-
Rinnai Water Heater RUR98i (REU-KBP3237FFUD-US) Specification Sheet
2 pages
-
Rinnai Water Heater RUR98i (REU-KBP3237FFUD-US) Operation and Installation Manual
61 pages
-
Rinnai Water Heater RUC80i (REU-KBD2530FFUD) Operation and Installation Manual
140 pages
-
Rinnai Water Heater RUC98i (REU-KBD3237FFUD) Operation and Installation Manual
140 pages
-
Rinnai Water Heater RUC98i (REU-KBD3237FFUD) Specification Sheet
2 pages
-
Rinnai Water Heater RL94i (REU-VC2837FFUD-US) Specification Sheet
2 pages